PrusaXL Filament Drybox with Ball bearings for low rolling resistance
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
PrusaXL Drybox, ball bearings, low rolling resistance, hygrometer, m6 ptfe tube fitting, silica
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 145
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This drybox fits standard diameter spools, of any width. It is compatible with the 2kg Prusament spools. Spools with smaller diameters will not sit on the roller bearings, but should still be compatible as long as they fit around the central pillar.
This drybox requires the following parts:
- 4x 8x22x7mm ball bearings
- 1x Hygrometer, the same one as on the prusaxl enclosure
- 1x m3 heat insert
- 1x m3x12mm screw
- 1x M6x5mm heat insert (optional)
- 1x M6 ptfe tube fitting (optional)
- 1x m4 screw
- stock screw without spacer
- 30mm screw with spacer
The drybox comes with a tube for holding silica beads. The funnel for inserting the beads screws right into the silica tube. The silica tube fits into the central pillar of the drum.
I recommend using a filament that doesn't creep. I used PETG.
The seals are to be printed with TPU.
The rollers, on which the filament spool will roll, need to be printed VERTICALLY to ensure perfect roundness, you will need to use supports. Use scarf joint to remove the seam, otherwise the spool will snag on the seam and not roll properly.
Attach the ball bearings on both sides on of the roller and insert the roller into the drum.
The optional m6 heat insert is to be put in the slot at the filament hole on the outside of the drum. This is where you will screw the optional m6 ptfe tube fitting into.
The hole for the m3 heat insert is on the outside side of the lid. Insert the heat insert and then attach the grip via the M3x12mm screw. The grip should fit snugly into the hexagonal slot.
I recommend attaching the hygrometer with hot glue for a better seal, but it is not necessary.