infini-T-slot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed this 2-part t-slot with a tongue-and-groove that fit into each other. You can make a 100mm rail by flipping…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 36
- Wydruki
- 1
- Wyświetlenia
- 564
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I designed this 2-part t-slot with a tongue-and-groove that fit into each other. You can make a 100mm rail by flipping one half upside down before connecting them. More importantly though, you can make an infinitely long t-slotted rail by leaving both halves facing "up", and staggering them on either side. This solves the problem of not being able to print out large structural components.
I printed this one out of PLA at 250 microns with 20% infill. It seems quite strong, and the tolerances are tight enough that you need a hammer to get them to slide into each other.
Category: 3D Printer Parts