8AN and 6AN Fuel Line Bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bracket for 8AN and 6AN braided fuel line.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 260
- Wydruki
- 0
- Wyświetlenia
- 1204
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Public Domain
I based the dimensions for the the hose openings off of Radium PTFE black carbon braided hose. So fit might be a little different with other hose.
The center hole is designed for an M4x25 socket head screw and threaded insert. The hole for the insert is designed so that you insert it from the top (long flat side) and push it in until you hit the smaller bore (just make sure it sits flush or slightly recessed into the bore). This will keep the insert from pulling out when you tighten the retaining screw down. Threaded insert hole is designed to be inserted with heat.
The mounting hardware hole is designed to fit an M6 socket screw head but it will also accommodate smaller self-tapping screw heads as well.
The orientation that each part opens in your slicer in is the ideal printing orientation for strength. It will also ensure the cleanest, most accurate screw holes and won't require any supports.
Will probably want to use ABS or ASA at the very least. I personally use ASA but of course stronger filaments would be even better.