1 / 4
EP Legs/Stilts for the Teenage Engineering EP-133 KO II , EP-1320 Medieval, and EP-40 Riddim — zdjęcie 1
1 / 4

EP Legs/Stilts for the Teenage Engineering EP-133 KO II , EP-1320 Medieval, and EP-40 Riddim

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Stackable legs/stand for the LEGO Technic pin holes on the sides of the EP series of Teenage Engineering machines.

Ocena
5 / 5
Polubienia
11
Pobrania
46
Wydruki
1
Wyświetlenia
505
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Music
Licencja
BSD License

After I bought the EP-40 "Riddim", I now had three Teenage Engineering EP units, and had a new problem on my hands, storing them in such a way that I can access them quickly.

Hence this design, inspired from banquet or conference stacking/nesting chairs, these legs clip onto as many EP units using LEGO Technic pins, and allow angled play of the devices and then immediately can be transitioned into a parallel stack of devices for easy hand carry and storage on top of a small shelf or cabinet.

Designed to provide ample room above the knobs and fader, access to the battery compartment without having to remove.

I recommend installing small rubber pads or feet under the legs, as most filaments will likely be slippery on your desk or play surface.

Mine are printed in PETG at 0.2mm layer height, with a 0.4mm nozzle.

Slicer supports are not needed, as all supports are provided in the STL, and are easily removed with a pair of needle nose pliers. Snap off the overhang supports and pop out the LEGO Technic pin holes.

Designed in OnShape non-commercial license.

Tagi