Hotbed carriage for linear rod upgrade for Voxelab Aquila Y-Axis

This is a hotbed carriage for linear rod upgrade for the Voxelab Aquila printers Y-Axis. This is designed to be used with the Y-axis rod mounts from https://www.printables.com/model/446502-ender-3-v2-x-and-y-linear-rodshaft-upgrade. This will have the correct hole pattern for the existing metal bed frame on the Aquila, and may work with others. STL's and STEP files are included.

You will need:

16 - Voron spec M3 heatset inserts (M3 x 5 x 4)

16 - M3 6mm screws

4 - M5 8-10mm heatset inserts - Mine are not Voron spec, and are 6.1mm at their smallest diameter. If your inserts are larger, you may need to enlarge the hole.

4 - M5x12mm Screws

4 - LM8UU bearings (Make sure you've greased your bearings prior to assembly)

and all the printed and purchased parts for the Y-axis (sans bed carriage) from the Ender linear rod conversion linked above.

To assemble, insert you LM8UU bearings into the top piece (they should snap in), making sure to orient the internal bearing races so that they are in an X config with regard to the linear shaft. Then add the correct bottom piece and secure with 4 screws for each bearing. Make note that the piece with the long chin goes to the rear where it impacts the Y-axis endstop. Mount to the printer by inserting the rods partially through the front Y-axis mount, then through the carriage and bearings, and then into the rear Y-axis mount.