Accelerometer box improved, All-orientation lid closure, MK4S Core One, Original Prusa Accelerometer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a slightly adjusted remix to enable closing the lid in any orientation!
- Ocena
- 4,333 / 5
- Polubienia
- 13
- Pobrania
- 60
- Wydruki
- 3
- Wyświetlenia
- 452
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a slightly adjusted version of the Accelerometer box from Habony Norbert, For more intuitive closing of the box!
The only difference is instead of using 4 grooves on the box (main body), that required the lid to be lined-up when closing, in this mod I make it into a continuous groove all around, so no need to line up anymore.
For the lid, please download it from the original model page, here.
………………………………………………….
Printed part guide⚠ :
Please note that this is just a 15-min project, I didn't redesign from scratch, while I only have limiting skill for editing STL mesh.
⚠ Therefore, the models have some bugs to be fixed, you must print with layer height equal or greater than 0.25mm, otherwise some issue will appear when slicing!
⚠ If you want to use smaller layer-height, choose the variant for small layer height, but mind that some edges may look a bit wobbly, due to the poor fixing of mesh-issue.