Mille Fiori Compatible Board Game Insert

This insert is designed to have one box per player, and a card tray to hold the cards. Print 4 player boxes in your desired colors. 

Print one of each player lid. The lids are perfectly square, but depending on your printer, filament, and settings the lid could be too loose or too tight. If it is too loose, reprint by making the X and Y directions larger by 0.1 or 0.2mm. If it is too tight you may sand a little off the edge or reprint 0.1 or 0.2mm smaller in the X and Y directions.

Print one Draft Cards tray and lid. If you find them too tight or too loose you can reprint .1-.2 mm larger in the X and Y directions. Make sure to manually adjust the X and Y measurements and unlock scaling so it doesn’t scale the rest of the model. Be aware that it will slightly loosen over time, so err on the side of tight. Make sure your adhesion is good for best results. 

Expansion: Print the Masterpieces tray and lid with the same instructions as above. Print one Palace Box. For a little bit of added flair print this crown instead of the Doge card. (Not my design) 

Happy gaming!

________________________________________________________________________________________

Check out all my free designs here on Printables! If you want to support my work and all of the free designs I bring to the community consider buying something from my Etsy shop or my Printables Store.