1 / 2
Filmament holder for 34mm tubing — zdjęcie 1
1 / 2

Filmament holder for 34mm tubing

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple filament holder which supports 34mm tubing.

Ocena
0 / 5
Polubienia
23
Pobrania
51
Wydruki
0
Wyświetlenia
254
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

I have created this simple filament holder which supports electrical tubing with a diameter of around 34mm. The tubing is squeezed to guarantee a tight fit. The actual diameter of the holder is 31mm, so you might get away with slightly smaller tubing as well.

With this design, you can print off the wall if you have your printer located close to it. I have my two Vorons right below and it works great for 1kg spools, but your  results may vary based on the pulling power of your extruder.

Simply print two and saw the tubing to length. 

Print setting need nothing special, I used PLA with 0.2 layer height and 40% infill, 4 walls.

Tagi