Photo Suspender

This photo frame came from a desire to hang a number of photos cheaply and to be able to switch photos out from time to time.
These are designed to be mounted vertically using Poster Hanging Command Strip so they can be removed cleanly from the surface they are mounted too.  

I have included the files for 3, 4, 5, and 6 inch sizes as I have only tested photos with these sizes. To make sure your photo will fit, measure along the vertical axis when your photo is oriented the way you would display it in either landscape or portrait. I would recommend using photo paper and not a standard copy paper as this design depends on the rigidity of the photo paper to display well and not curl.

The fusion 360 source files are attached. The model is parameterized based on the needed variables of photo size. The PhotoHeight in mm and PhotoThickness in mm. I would recommend leaving PhotoThickness and MainThickness settings be unless necessary.

I am in no way affiliated with 3M or the Command Strip Brand. I am just a fan of the simplicity of the product. Other brands of double sided tape may work just fine.

*From my experience, I would not recommend using command strip on matte and eggshell paints as there is more risk of damage when removing on these finishes.
*I do not recommend mounting these next to a door or any other source of heavy air flow.
*To remove, flex the bottom part up a bit and pull the Command Strip straight down slowly.

I hope this works well for you if you choose to print it!