1 / 1
FPL Part V: Stand/Holder for volumetric pipettes — zdjęcie 1

FPL Part V: Stand/Holder for volumetric pipettes

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Lets go classic, lets go glas! Easy to print pipette stand for volumetric pipettes, no supports needed.

Ocena
0 / 5
Polubienia
2
Pobrania
52
Wydruki
0
Wyświetlenia
181
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

When storing your classic pipettes it always comes quite shocking when you see how much a simple pipette stand will cost you.

So the answer is quite easy, just print it yourself. This stand consists of three parts, each prints without supports. Just connect the parts by the already in the model included threads and you are good to go. The stand features two different sizes of holes suitable for pipettes from 1 mL to 25 mL.

You can use standard PLA or switch to PETG for better chemical resistance or even go PCTG. 0.4 nozzle, 0.2 layer and 15% infill will do the job

Check out my other parts of the Fully printable lab:

https://www.printables.com/model/789718-fpl-fully-printable-lab-part-i-lab-stand

https://www.printables.com/model/893614-fpl-fully-printable-lab-part-iii-drying-rack-for-v

https://www.printables.com/model/1119828-fpl-part-iv-10x-test-tube-stand-round

https://www.printables.com/model/857006-fpl-fully-printable-lab-part-ii-volumetric-flask-p

As always have fun and share and remix.

Tagi