2006 Forester Tail Light Stud
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
1/1/2025: Added .obj and .step files in case someone wants to modify it.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
1/1/2025: Added .obj and .step files in case someone wants to modify it.
This is a mounting stud (clip) for a 2006 Subaru Forester tail light. They easily break off when removing the tail light from the vehicle.
I took RCAholic's design (https://www.thingiverse.com/thing:3553603) for the bottom stud (there are 3 in total for each tail light), scaled it to the correct size, and removed the screw portion because it's almost imposible to remove from an old tail light once it's broken off. This can also be used for the other two studs that are part of a bracket, and not screwed in to the housing.
Tall file is for the bottom stud Short file is for the other two on the white bracket
To mount take a 5/64 drill bit, drill a hole in the center of where the old stud broke off, then glue the new one into place.
I printed mine using PLA, but if you have ABS that would be recommended since it is more durable and has a hight temperature tolerance
Print Settings
Printer Brand: Creality
Printer: Ender 3
Rafts: Yes
Supports: No
Resolution: .08
Infill: 100
Filament: Any PLA Any
Notes: Used Siepie-CR 10-Ender-3 Small Minis-PLA-Base 1.0 Cura profile, modified Printing Temperature Initial Layer to be 205 degrees C.
https://www.3dprintedtabletop.com/resources/3d-printing-profiles/
Category: Automotive