1 / 9
CISCO / Meraki GO GR 62 Wall Mount Wandhalter Halter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
1:1 Copy of the original Mount
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 52
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 1:1 Copy of the original Mount. Make sure your printer is well calibrated, since the tolerances are pretty tight. You can use any Material you like. For Outdoor use consider a Material like ASA.
The original mount is made of PC, so I used PA-CF.
The thread insert isn't necessary, I used Ruthex M3x5x4 mm. Support is required.