D2F Microswitch JST adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Description: A 3D printable alternative to Solder and JST-D2F PCBs for microswitches. Designed for use with ERCF v3.
BOM (per microswitch)
5 pin JST-XH connector - x1
Printing instructions: Use ABS, 0.2mm layer height is fine. Increased cooling may result in a more fragile end result, the model was designed with minimal overhangs to avoid needing it.
Assembly instructions: Remove the microswitch mounting screws, place the adapter onto the microswitch, then screw the assembly back on using the same m2x10 screws you were already using. The adapter now functions as a 5pin JST-XH receptacle, and requires no additional hardware.
ADDITIONAL IMPORTANT INFO:
In order for the adapter to clear the ERCF components without interfering with normal operation, one side of the connector is open. Take care to align the JST connector properly with the adapter and microswitch pins to avoid bending the pins. It also may require more force than expected to fully seat the connector, this is normal.
As a precautionary measure, it is recommended to use emery paper on the microswitch pins to remove any potential oxidation.