Chamber heater for Core One, Creality standalone unit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple addition of Crealitys chamber heater for quicker warm up
- Ocena
- 5 / 5
- Polubienia
- 55
- Pobrania
- 141
- Wydruki
- 3
- Wyświetlenia
- 2360
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
A simple box to put Crealitys chamber heater in the Core One side panel to heat the primary print area, to make heating up in cold environments significantly faster. It works well and heats up the chamber very quickly in combination with the heat bed. Its primarily made for heating up the chamber, but can add a little heat to keep it at 55-60ish degrees. The little angle can be glued in to keep warm air to blow over the rubber belts. This is just my first prototype to help my long cold starts, any improvements are welcome.
To run the heater you just set the temperature (it measures at the air inlet in the back) and go, to save the electronics keep the temp below 60degC. Use at your own risk with care.
I split it (see the 3mf) and printed it in Prusament PCCF, with the clamp clued over the split to increase the glue are. It could probably be printed in ASA aswell if the silicone case is used as the unit doesnt transmit as much heat. Holes might be a little tight and need a trim, I used M3 screws and nuts, since the heater is heavy