Headphone Headband with Vision Pro Knit Strap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
headphone headband that uses the Apple Vision Pro knit band and thin metal hair bands
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 140
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
update v2: ear cups holder updated, print in one piece no need assembly.
I made a custom headband for over-ear headphones (I did these for the omega dms open-source headphones) using an Apple Vision Pro knit band, a set of thin blank metal hairband strips, and a few 3D printed parts I designed.
Start by cutting the metal headbands to the right length. Just place one on your head, eyeball the size, and trim it with pliers, bend back and forth a few times and it snaps easily.
Print the two-hole connector piece two or three times depending on how much support you want. I used three: one at the top and one on each side. These hold the dual metal bands together.
Superglue is enough for basically everything.
Use an M4 bolt and a heat-insert to connect the top section to the lower ear-cup section.
You can adapt the design to fit an Audeze leather headband if you prefer, I’m leaving the STEP files for that.
As for the Vision Pro knit band people are selling their single knit bands cheap now because the newer dual strap is out, so it’s a good time to buy a used one. New also works fine.
If you want to dye the band like mine, look up guides online or check the Bigscreen Beyond VR Discord. Someone there wrote a full tutorial using Rit DyeMore (for synthetics) on low heat for about an hour. Worked perfectly for me.