Ender 3, 3 Pro v1 Dual Z Upgrade PSU Mounting Brackets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stronger PSU mount to use with a dual Z axis upgrade for an Ender 3 or 3 Pro v1.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I bought a Dual Z Upgrade Kit for my Ender 3 Pro awhile back. The PSU had to be relocated. The bracket that came with the kit was pretty flimsy (see the second picture). The back bracket broke, so I had to make a new bracket.
I made two different versions. The third picture shows the version of the rear bracket with an attached extrusion cap. The fourth picture shows the version without the extrusion cap.
The last picture shows the front bracket. It is used with either version of the back bracket. The front bracket also has an extra mounting hole. You'll have to remove one of the screws in the PSU and replace it with an M4x10 screw. It's not the same as the type of screw that came out, but you can still tighten it.
You'll also need 4 M4x10 screws and T nuts to attach the brackets to the extrusion rails and 3 more M4x10 screws to attach the PSU to the brackets.
Here's the link to the kit I used. I don't get compensation, just FYI.