N-Type Adapter for Keepteen D5 Solar Charger Meshcore
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter to allow an N-Type socket to be fitted to a Keepteen D5 Solar Charging unit at an appropriate angle.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 193
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This adapter allows an N-Type socket with a short pigtail (5cm min) to be fitted to a Keepteen D5 Solar charging unit that has had it's charging board removed and replaced with other modules boards.
There is a tilt on the adapter to allow the vertical antenna to remain oriented as it should be to the horizon leaving the panel with an angle for optimum solar power unlike the SMA sockets often fitted in to these units requiring hinged antennas. The panel angle is 55 degrees, can add other angles if needed.
The threading on the top allows for a rear screw N-Type socket to be screwed in with a short cable/pigtail already attached. Two STLs are here, one with a very tight thread fit, the other looser. The adapter will need glued/epoxied on to the D5. Print with the threaded side on the plate.
There are also STLs for a USB weather cover (thin walls, make sure and seal the inside up too) and a non threaded barrel cover should it be required.
Picture is of it only loosely attached/screwed in. I'd suggest self amalgamating tape over the connector/top of printed part.