Electrohub Drilling Jig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple jig for drilling the mounting holes for the Flitetest Electrohub and fits 1/2 inch wooden dowels. The…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 157
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
A simple jig for drilling the mounting holes for the Flitetest Electrohub and fits 1/2 inch wooden dowels. The unmarked hole in the end should be drilled through regardless of the configuration of the copter. The X holes are for an X configuration quad (should work with hexacopters or octocopters as well) and the S hole is for a spider configuration quad (AKA dead cat quad). It makes consistent, precise drilling much easier and lends to a nicer overall build.
Update: The jig was just a little too long from the end to the first hole. This has been corrected to the ~6mm recommended by flitetest. The original version of this jig was 1-2mm too long for the spider quad booms.
Print Settings
Printer:
Davinci 1.0a with Repetier
Rafts:
No
Supports:
Yes
Resolution:
Any
Infill:
10%
Category: R/C Vehicles