3508 Motor Mount for .5 inch dowels
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed this design to be able to fit over 1/2" pine dowels used on my Flitetest Electrohub. They fit great and seem…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 104
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I remixed this design to be able to fit over 1/2" pine dowels used on my Flitetest Electrohub. They fit great and seem like they'll be quite strong. They use a standard 25mm x 25mm mounting hole spacing.
Print Settings
Printer:
Davinci 1.0a with Repetier
Rafts:
No
Supports:
Yes
Resolution:
0.3mm
Infill:
50% or higher
Notes:
These fit the dowels very tightly. Depending on your dowel, you may have to shave or sand down the end to slide these over the end. A standard M3 screw passes through the mount and the arm to secure it. Make sure you print at a high enough temperature to get good layer adhesion as there is direct stress on the layer bond and that is the most likely place for it to break. A zip tie around the mount could be used as a precaution if you feel it is necessary.
These also extend the arm length a bit which, depending on your design, may allow for slightly larger props.Category: R/C Vehicles