1 / 3
Archery Finger Tab
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Based on models I'd seen online, This tab sandwiches leather between two printed plates. A ring screws in through the whole assembly and acts as a finger spacer. Used 3 pieces of leather (about 1mm thick each) PDF of leather pattern included in files. Ring diameter is 21.5 mm
MIRROR FILES FOR LEFT HAND VERSION
M3 and M4 taps required-- threads are cut right into the plastic.
The M4 tap is run in the ring's hole, the M3 tap is run through all of the smaller holes on the rear plate.
Used M3x8 screws, and an M4x 12 screw