Samsung 7000 Series TV Low Profile Replacement Foot

This is a replacement foot designed for the Samsung UN43TU7000 TV.  This foot is designed to have the TV sit about 5 cm/2 in lower than it would with the stock feet.  

This is only the left foot and will require mirroring to print the right foot.  The model has “LF” printed on it to show which side it goes to and to indicate that it is the front side of the TV.  When properly mirrored, the text will be reversed and read “ᖷ⅃”.  Please note that the left-side foot, “L”, is intended to keep consistency with the markings on the OE feet and is on the left side of the TV when it is face-down on a table as is described in the initial set-up instructions.  Left and right will be flipped when looking at the front of the TV.

I printed this in two parts, split right down the middle (using Banana Split in Cura) so that they would lay flat on the bed and then I glued the parts together using cyanoacrylate with strong clamping using large binder clips.   The seams are visible in the images.  I used supports for the holes that are cut out in the head of the model.

I printed this in PETG with good results, but the material choice is yours.  I would stay away from standard PLA because it is probably too brittle for this application.  The original equipment claims to be made from a polypropylene blend.

Once printed and glued, you may want to put anti-skid silicone or rubber pads on the flat section of the feet to reduce sliding and chatter from moving around.

It will likely fit most 7000 series TVs and possibly other series Samsung TVs, but I haven't tested.   Please let me know if it fits other TV models so that I can list them here.

Please take care to not damage your TV when manipulating it to install these feet and ensure that your print came out strong enough to be suitable for this purpose before putting the feet into service.