Veloci-Straptor - Fast cable ties [OpenSCAD]
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fast and efficient cable tie system in TPU that you can customize however you like. You'll use them everywhere.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 142
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
I'm building out a new (but tiny) workshop and need a way to organize all my cables and cords. After trying a few other TPU cable ties, I didn't find what I was looking for: minimal filament required, a solid feeling snap, easy release, and a way to manage any extra tail left over. Plus, I wanted to have it in OpenSCAD so I could customize parameters as needed for new situations.
The result is Veloci-Straptor. Attaching quickly to whatever new home you give it, it's fast to print, fast to wrap, and fast to release. You'll find it sneaking into your workflow in surprising places. You might even find yourself complimenting it under your breath: “Clever curl.”
How fast do they print? I printed the full flight of 25 straps seen in the photo in about 3.5 hours on a Prusa MK3S+. Or print one in just 5 or 10 minutes, depending on size.
Instructions:
I print mine in TPU at 0.3mm per layer and 3 perimeters. No supports required.