Silvercrest SKWH2000 B2 heater remote holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
i kept losing my remote, so i made a holder for it
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 24
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Public Domain
I put the Silvercrest (checks notes) SKWH2000 B2 in my bathroom becuase it gets colder than the artic in there, but i didnt want to just have the remote somewhere willy nilly, so i created this little holder to VHB onto the wall to use like a thermostat.
i made it for the SKWH2000 B2 remote, but this is just a pretty standard looking cheap electronics remote, but if you have a 40mm(w)x86mm(t)x68mm thick remote, this should work for you too.
i exported it laying flat but i recommend printing vertically, with the U shap closer to the bed, this is the least amount of supports (none) and as this is likely a handle once and forget, layer bnding isnt super important. i printed out of a white PLA to match the bathroom, you do you boo