6W Soshine Solar Enclosure Remix.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the 6W Solar Enclosure by Voltaic Enclosures.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 519
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This modification allows you to power the LoRa module in another housing from a distance. (split) since coax has a lot of loss on RF at these frequencies. you can attach the LoRa device close to or directly to the antenna, and mount this enclosure lower on the pole for easy access.
You can use those cheap battery holders sold on Amazon, or print up your own, I recommend these. If you print your own, you will need battery contacts. the sled has mounting holes for either one.
The holes are for cable glands, you can easily modify the holes using tinkercad for whatever size glands you have available. one is for the power in from the Soshine 6W solar panels (6 volt output) the other hole is for the power out to your LoRa (meshtastic) module. I use a cheap TP4056 module as a charge controller.
There is a good housing for the LoRa module, I recommend this one , this one works well with Faketec, Heltec V3 and V4. I did not use the power arrangement in the original design, and sealed one of the holes on the bottom.
Optional:
You could probably fit a LoRa module inside this case, and put a N-connector on the case, as in the original design, and feed an antenna from it as the unmixed version was designed for, the advantage of this remixed, is you have more room that allows for 2 18650 batteries.
All the other STL files ( Solar panel holder ) can be downloaded from the OG, nothing needs to be changed.
Also note there are other mods and remixes for OG's design, including various pole mount clamps. so look around for the one that best suits you.