Scratch Attach - Printed, Telescopic Back Scratcher v2.0 - BEEFIER - the "I have grandkids" edition!

v2.0 is made to be BEEFIER - it's the "I have grandkids" edition! v1.0 has 1mm thick sidewalls on the telescopic handle, while v2.0 has 2mm thick sidewalls on the telescopic handle. I kept the same outer diameter on the final by (a) dropping from 4 sections to 3 sections on the telescopic handle, and (b) making the overall print height slightly greater. This edition also has an added option for the business end, courtesy of the great remix by @Boomerguy_775659.

The following is all copied and pasted from v1.0 listing (except revised print time, size, etc).

This short (90 sec.) video shows all you need to know:

The Best Back Scratcher You've Never Had To Buy! 

Printed on my fast CoreXY printer (Flashforge Adventurer 5M) in 2 hours. 

Expands from 260 mm to 530 mm! That's 10.25" to 21" in Freedom Units!

• Printed in PLA.
• Print as oriented.
• No supports needed.
• Scratcher part should be a press fit. If loose, add a dab of CA glue.
• Secure the base cap on the bottom using some CA glue.

Also, a new Scratch Attach “tip” has been made (as a remix), so now there are choices for the scratch attach “business end“! See link below, and thanks to @Boomerguy_775659 for the remix!

https://www.printables.com/model/1029675-classic-scratcher-tip-for-scratch-attach

Check out my many other models, and check out my designer club! https://www.printables.com/@design8studio/models 

My PayPal tip jar: https://paypal.me/design8studio 

Tagged: Scratch Attack

Change log:

• November 30, 2025 - initial upload