Magic The Gathering - Jumpstart Cube

I wanted a nice looking box to hold my Magic the Gathering Jumpstart Duel packs without angering the wife with cards all over the table. I designed this to look nice on the table while also being functional for when my daughter, her friends, or I play. I have been using the locking jumpstart reusable pack from Libery300 (linked below) to hold one jumpstart pack in sleeves. You can use this without the reusable packs but I made this box to support those packs which also keeps it a blind draw.

The idea is simple
I put 12 jumpstart packs into cheap gamestop sleeves and place them inside the reusable packs. You roll the dice to choose which 2 jumpstart packs are combined to make the deck. Lastly you play!

How I solved the same color jumpstarts shuffled in same color sleeves is
I used a black fine tip sharpie and touched the same corner on the back of the sleeves for that jumpstart pack (a different corner for a different same color pack). While it is marking the card sleeve, you can only see the mark under bright light up close. That dot makes it easy to un-shuffle the cards back into their pack.

Printer specifics
Printer Anycubic Kobra S1 (I'm poor and can't afford a Prusa)
0.4 nozzle
0.2 layer hight
2 walls
15% infill
You can use this with or without a multi-color printer as this is designed for layer hight
My print time for the box is roughly 16 hours
I use roughly 600g of filament with the total cost around $12 bucks.

This print has very tight tolerances so I would put the lid on and remove it a couple times and then it is perfect for me.

I highly recommend using these jumpstart reusable packs:
https://www.printables.com/model/1064629-mtg-cube-locking-reusable-pack

Please comment and share pictures if you make it and enjoy it.
If you like the model and want to tip (er help support my daughter's cardboard fund), buy me a coffee link is below (no pressure, times are hard for everyone). 
https://buymeacoffee.com/crozz
 

Reach to me with any questions you may have