Polarpro Litechaser 17 grip SSD holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made to hold an ugreen m2 ssd enclosure without obstructing lens or function buttons.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial
Careful!!! the print is using tight tolerances, so if the print doesn't slide in easily on the cold shoe mount do not force it, it will get very stuck (speaking from experience) remove some material and test it.
This did print fine on my X1C after some iterations, just a warning :)
2 walls 15% infill made it very easy for the cold shot mount to fit.
100% infill made it very tight, model adjusted to be printed this way but if print is too tight and you don't want to remove material manually just use less infill, it will still be strong!
Print it laying down on the side, no need for supports.
Use any filament you want! i've printed it in PLA and PETG-CF.
I'm using a very short angled 0.14m usb C cable from hagibis, but it is needed to remove some material from the case for it to connect properly.