1 / 1
Filament holder axle with load cell and bearings for filament scale — zdjęcie 1

Filament holder axle with load cell and bearings for filament scale

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a filament spool axle for a holder with a load cell. Intended as generic part of filament scale.

Ocena
0 / 5
Polubienia
2
Pobrania
8
Wydruki
1
Wyświetlenia
115
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

Overview

This is the filament spool axle for a filament holder equipped with a load cell. A brake may optionally be installed to limit coasting.

Designed in FreeCAD, source files included.

Designed as an extension/replacement of the original project axle:

Print Settings

The 3MF file created in OrcaSlicer is included.

Material: PLA
Layer Height: 0.2 mm
Perimeters: 4
Top/Bottom Layers: 4
Infill: Gyroid 40%
Supports: Yes

Bill of Materials (BOM)

  • 2pcs ... 61804 Bearing

  • 2pcs ... M4x16 PH2

  • 1pc ... YZC-131

  • Rubber seal 3/4" DN20 30x20x2 - Optional for brake

Assembly Instructions

Mechanical assembly

  1. Check the bearings are firmly fitted/seated on the shaft (inner) and in the housing (outer).

  2. Housing Installation: Install the Bearing Housing (Through-Bore) onto the load cell. Place the bearing onto the housing. Secure the housing with a screw.


  3. Spinner: Mount the Spinner.


  4. Housing Preparation: Install the bearing into the Bearing Housing (Blind-Bore). Place the rubber seal, if you intend to use the braking function.


  5. Final Assembly and Adjustment: Mount the prepared housing onto the load cell. Ensure that the bearings are seated against (resting on) the housings and the spinner. Apply pressure to the outer center of the housing. If you have installed the rubber seal as a brake, the force used for pressing defines the braking effect.


  6. Secure the assembly with the screw. FINISHED :)

Electronic assembly / Software

No software or electronics is required for this assembly. This assembly is part of the weight measurement system, which is equipped with a dedicated electronic device and software, such as https://github.com/vmalat/UltimateFilamentScale

Disclaimer

The creator is not liable for any damage to your hardware or any unintended results caused by the use of this project, its code, or its documentation. Use at your own risk.

Tagi