Tripod Claw Foot Holder, Washers and Covers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder, washers and covers for Selens FT-01 tripod claw feet
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 47
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
I wanted a means of safely storing the claw feet for my tripod when travelling with them and the tripod in a suitcase.
also wanted to make sure that the bottom of each leg was a water tight as possible when fitted with the Selens FT-01 claw foot.
For simplicity the covers are printed as two halve (base & cover) and then superglued together. To date this has been a reliable solution.
The parts are a snug fit to avoid them failing off during travel.
Best printed in TPU with 40% infill to give enough strength whilst still being reasonably flexible.