20mm Irrigation Hose Ground Stakes (Set of 2) – Low-Cost, High-Grip Outdoor Design (PETG Recommended)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple, durable and affordable solution to organize irrigation systems in the garden.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 81
- Wydruki
- 0
- Wyświetlenia
- 170
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
A simple, durable and affordable solution to organize irrigation systems in the garden.
1. Deep Ground Spike
The tapered spike penetrates soil, mulch or compost smoothly and anchors firmly so the stake does not loosen over time.
2. High-Grip Tooth System
The top section features angled retention teeth designed specifically for 20 mm hoses.
These teeth:
• Prevent the hose from popping out
• Maintain a firm hold even under tension
• Allow easy insertion but resist upward movement
• Avoid crushing or deforming the hose
This makes the stake efficient, reliable, and perfect for long watering lines.
Compatibility
✔ 20 mm irrigation hoses (mainline type)
✔ Garden hoses of similar outer diameter
✔ Works in raised beds, orchards, garden beds, and along pathways
✘ Not suitable for very soft micro-tubing (use micro stakes instead)
Recommended Materials
✔ PETG – Best for UV resistance, outdoor durability, and heat tolerance
✔ PLA+ – Acceptable for seasonal or shaded areas
✘ Regular PLA not recommended for full-sun exposure
Print Settings (Ender 3 V3 SE – recommended)
• Material: PETG
• Nozzle: 0.4 mm
• Layer height: 0.20 mm
• Infill: 25–30% (Cubic or Gyroid)
• Supports: Not required
• Bed adhesion: Skirt
• Speed: 60–80 mm/s for PETG
• Orientation: Flat side down
• Walls: 3 perimeters
• Top/Bottom: 3–4 layers
Print time: ~35–40 minutes for the set of 2
Material usage: ~8–10 g total (very economical)
How to Use
Lay your 20 mm irrigation hose in the desired position.
Place the stake over the hose.
Push the spike straight into the soil until stable.
Add more stakes as needed along the hose path.
They hold the hose:
• Straight
• Low to the ground
• Resistant to accidental pulls
• Stable during watering cycles
Notes
• Designed for efficiency and low-cost printing—ideal if you need dozens across a large garden.
• Stronger and more reliable than typical thin plastic clips.
• If you liked this model, please leave a Like or comment on Printables ✨