1 / 2
The best little supressor for 5,5 Fx Impact M4 — zdjęcie 1
1 / 2

The best little supressor for 5,5 Fx Impact M4

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A supressor for 5,5 Fx Impact based on a felt.

Ocena
0 / 5
Polubienia
23
Pobrania
228
Wydruki
0
Wyświetlenia
1864
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I designed and tested several moderators for my FX Impact (½ UNF) and this small one, with a felt design, is the one that gave me the best results. The idea was to design a suppressor for the Impact M4 that would maintain the barrel line at the same diameter (28 mm) without affecting accuracy.

All parts are printed in PLA with a 30% infill density. The piece labeled "Felt" must be printed with the following settings on your Orca slider: Infill pattern spacing: Gyroid, Wall loop = 0, top shell layer = 0 and bottom shell layer = 0.

Once both axles are inserted inside the Felt and the Felt inside the Tube , glue the cap on  with cyanoacrylate adhesive (I recommend incorporating an o-ring of 15x1 mm between the axle and the cap to maintain tension inside).

And that's it.

Shooting 18 grains at 900 fps: 75dB, all you hear is the hammer strike and the impact on the target.

--


Diseñé y probé varios moderadores para mi FX Impact, y este pequeño, con diseño de fieltro, es el que me dio los mejores resultados. La idea era diseñar un supresor para la Impact M4 que mantuviera la línea del cañón al mismo diámetro (28 mm) sin afectar la precisión.

Todas las piezas están impresas en PLA con una densidad de relleno del 30 %. La pieza etiquetada como "Fieltro" debe imprimirse con la siguiente configuración en el deslizador Orca: Espaciado del patrón de relleno: Giroide, Bucle de pared = 0, Capa superior de la carcasa = 0 y Capa inferior de la carcasa = 0.

Una vez insertados ambos ejes en el fieltro y este en el tubo, pegue la tapa con adhesivo de cianoacrilato (recomiendo incorporar una junta tórica de 15 x 1 mm entre el eje y la tapa para mantener la tensión en el interior).

Y listo.

Disparando 18 granos a 900 fps: 75dB, solo se oye el golpe del martillo y el impacto en el objetivo.

Tagi