Minecraft Lantern Revamped (STEP-File included)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This a a complete redesign of the Minecraft Lantern by Nando. It can be adjusted for any size and e-tealight diameter.
- Ocena
- 5 / 5
- Polubienia
- 123
- Pobrania
- 271
- Wydruki
- 1
- Wyświetlenia
- 1334
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Share Alike
This Minecraft Lantern inspired model brings cozy pixely warmth to every home.
Caution
Never use real tealights, candles or other burning materials with this model. Best case they're starved of oxygen, worst case your home burns down. Only use electrical tealights/candles!
Needed Materials
electrical tealight with 37.75mm diameter (can be adjusted via parameter in the STEP file)
Optional: sandpaper or file (depending on your printer)
Printing
Material: PLA (I used PETG for the frame and PLA for the panes)
Layer Height: 0,2mm
Infill: 10-15%
Fill Pattern: Gyroid
Support not needed
Assembly
Optional: Sand the top holes and pegs if needed to ensure a friction fit without getting stuck
tip: drawing with a lead pencil on the pegs leaves a bit of carbon as residue which can act as lube
Add your electrical tealight or candle
Slide in the panes
you can decide if you want the layering to face out or in, both works fine
Put on the top part, making sure not to cant it
if the fit is too snug, you can carefully wiggle it free
note: if your need to open it, always go slowly, peg by peg and apply counter pressure to the peg you're currently wiggling to avoid it snapping off
if a peg snaps off, you can glue it on with superglue
Enjoy your cozy lantern!
Note
No Blåhaj were harmed in the making of this decor object.