KUSBA / BigTreeTech USB-C ADXL345 Magnetic bed mount (8mm round Neodymium magnets)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetically attach a BTT or KUSBA ADXL345 accelerometer to your bed using 8mm neodymium magnets & electrical tape
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 134
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Attach the KUSBA USB-C or BigTreeTech USB-C ADXL345 accelerometer to the bed holder using twelve (Maximum, you can try using less, say eight, but I'm not sure about the result.) 8 x 3 mm neodymium magnets. Adhere them with adhesive, making sure to observe the correct polarity. I compared the input shaper graphs with the model printed on the bed, and this one, and with the magnetic holder located right in the center of the bed, the graphs were more correct. The wall between the magnets is needed to ensure greater fixation of the plastic mount.
Description after is copied from the original model.
Attach a KUSBA USB-C or BigTreeTech USB-C ADXL345 to the print by pressing three M3 x H4 heat inserts underneath, OR by directly threading in two M3 x 6mm screws. I made mounting holes to support multiple ways to thread in screws!
Use two pieces of electrical tape under the magnets for additional adhesion to the bed to prevent sliding!
For additional adhesion, place the mount on a preheated bed!
Print material: PETG
Recommend print settings: 3 perimeter walls, 5 top layers, 5 bottom layers, 25% infill (gyroid/grid/honeycomb).
