BitAxe Gamma 601 minimalistic enclosure and stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimalistic Enclosure and Stand for BitAxe Gamma 601
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 82
- Wydruki
- 1
- Wyświetlenia
- 741
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
Very minimalistic enclosure and stand for BitAxe Gamma 601.
Well ventilated and good for overclocking.
M3 heat inserts are used for the fan casing that is attached to the enclosure.
M2 heat inserts are used for the enclosure to fixate the BitAxa Gamma 601.
The stand has a cavity on the bottom where cables can be routed to the fan on the back of the casing and they can then be gathered in the cavity on the back of the casing. I am using a PWM splitter cable so that the ASIC and case fan use the same settings. My version of the BitAxe only has one fan pinout.
Supports are only needed for the lip on which the BitAxe rests.
I have printed in ASA with 15% infill.
Can be printed on any printer with dimensional accuracy - it fits like a glove :)
UPDATED 2025-12-09: New version with fan covers for both Noctua NF-A4x10 and NF-A4X20.
These are the temperatures with just the stock fan on the ASIC running at 60% and no enclosure.
This is with the enclosure and the fan on the back attached running at 60%.
Beast mode with fans running at 100%.
