2d Christmas Ornaments (Set 1)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple and Timeless 2d Ornaments
- Ocena
- 0 / 5
- Polubienia
- 33
- Pobrania
- 154
- Wydruki
- 0
- Wyświetlenia
- 464
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter & Christmas & New Year's
- Licencja
- Creative Commons — Attribution — Noncommercial
These are some simple 2d Christmas Ornaments. This is a set of three. There shall be more, go to my account to check them out. They are 2.5mm thick in the original design (The thickness will depend on print size), so nice and sturdy, but not too thick to be too much. They all have a hole at the top so you can easily pull a thread through (how big the hole is also depends on the size of the print, mine work just fine)
Print Settings:
You can scale them to your desired size, I scaled mine so that they are all around 10 by 10 centimeters (110% or 120% depending on the ornament in Bambu Slicer).
Mine were printed in PLA, but PETG should work just fine.
I absolutely recommend using a brim so that adhesion issues can be prevented.
The print time varies depending on size, but if you print them one at a time, they shouldn't take long. I printed 3 at a time and they took around 1.5 hours.
I attached the Bambu gcode file that I used for my ornaments.
Have fun printing and feel free to post your makes! Merry Christmas!
Note: The original artwork is not mine. I only created the 3D printable file.
(Except for the Nativity one, where I tweaked the artwork to make it printable.)