On Ear Studio Sony Replacement Yoke
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement yoke for on-ear Sony monitor headphones such as the MDR V5, V4, 7504, V606 and the like
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 28
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution
There's 2 versions. "r-i" routs the cable a little bit through the housing where it meets the headband, while "r-o" routs it outside of it. A cable tie might be needed.
Both are the LEFT side by default, simply mirror during preparation for the right side.
Files should print it with the yoke prongs laying flat.
The cap also comes in 2 versions. With and without a through-hole.
Screw needed is an M3 12mm long for the hole version, if you wish to secure it with a nut on the other side. The version without the hole can take up to M3 8mm. It will start bulging starting at 6mm, but is only visible from the inside.
For optimal cable length I suggest you fully extend the headband while fitting and pull the cable into the earcup until you are happy with the remaining play, then reassemble it.