Master Spool with less flex and no jams
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I love Nefilatek material, been printing 10's of kg for months...but I was having spool jam issues. The filament would…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 164
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I love Nefilatek material, been printing 10's of kg for months...but I was having spool jam issues.
The filament would unwind well enough, but it would often get down between the floppy side of the master spool and the winding, then it would bind up and put a lot of tension on the extruder gears....this didn't go well.
So this is my attempt at fixing this issue and getting fewer failed prints, thus saving plastic.
Hope this helps.
Enjoy
...and try the Nefilatek recycled PETG, it is VERY good and prints super easy.
Category: 3D Printer Accessories