Slim Case for Pimoroni Plasma 2350 (W)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Press-fit case for the Pimoroni Plasma 2350 and Plasma 2350 W
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 70
- Wydruki
- 0
- Wyświetlenia
- 185
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
A basic case for the Plasma 2350 (W) from Pimoroni.
It assembles with the screw terminal wires already connected, so no need to thread cables through any holes. The USB-C and 4-pin JST-SH connectors remain accessible, and a small hole lets out light from the on-board LED. The A button is labeled as such on the lid, the boot button is labeled B, and the reset button has a reset symbol.
To assemble, insert three buttons into the lid, insert the microcontroller board into the base, then push together. Make sure your cables are connected to the screw terminals first, since the screws are covered once the case is closed up.
I did not leave an opening for the GPIO since I'm not using it, but you should be able to cut a hole for it easily enough directly in your slicer, through either the lid or base. I can make versions with the GPIO accessible if requested. The SP/CE connector exclusive to the non-W model is also covered.
There's 0.1 mm of clearance on the case parts and 0.2 mm for the buttons. Be careful of any horizontal expansion when printing, the buttons may end up stiff and get stuck pressed in if they're too snug.