1 / 1
Self-draining Succulent Planter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
No supports required!
Designed to minimize filament use, while maintaining strength!
Entire print fits inside a single Prusa MK3 bed!
All perimeters are sized to perfectly print with two perimeters with zero infill! (except the base frame)
- Frame sits on counter
- 4x Pot holder sits on frame
- at a 4.7 degree angle
- with standoffs, so water can run off easily under the pots
- with spout on the “low” end, for water to drain out into a sink or receptacle.
- 60mm Pots sit in the pot holder
- top of pots cut at same 4.7 degree angle, so they appear terraced.
- pots have a tonne of drainage, no matter their orientation - but not too much that soil drops out!
The end result is when you water your succulents, the water magically drains into the sink.