Down Range - Small Modular Building

This model is intended for use with Down Range, a tabletop wargame focused on fast-paced, tactical-level combat and teaching players about the use of emerging technology in modern warfare.

This model is a set of modular pieces to make roughly 4m x 4m at scale buildings. The ground floor variant has a door on the front and back; the upper floor is only windows, and the roof... well, it's a roof; not sure what more I can say about that. The tabs on the top and bottom let you securely stack the floors together.

While developed initially to print on a Prusa Core One printer, this model has been tested on Prusa Mk4, Mk4S, Core One, and XL printers using PLA filament without issue, and should work with most other manufacturers' printers. You may need to experiment with settings if you're printing in another material.

For the best balance between quality and print time, I recommend using an 0.2 mm layer height with organic supports, adding a 5 mm brim (especially important because of the flat bases and the possibility for warping as the print cools unevenly) and leaving the other settings as the default for your printer.