Laptop Stand - 16inch - Dual 144MM intakes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Made for the Zephyrus G16, or really any other 16 inch laptop with top/mid intakes
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 105
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
Made for the Zephyrus G16, or really any other 16 inch laptop with top/mid intakes.
Required Parts
1x Faceplate
2x Legs
Optional
1x Mid Leg
1x Brace
Some foam to make a seal around the output
Assembly
I used just standard normal M4 bolts, the length is forgiving as long as its over 16.5mm.
It may be possible to use glue, but I haven't tried. The design places most weight on the legs passively, and there is plenty of surface area so it should be possible but it's at your own risk if it holds.
The brace is optional being largely unnecessary if you used bolts, but possibly helpful if glue was used or for peace of mind.
The fans are to be attached on the OUTSIDE of the print, that is the side facing away from the laptop. The extra space on the front is to reduce turbulence and noise.
Printing
To print that faceplate in one piece requires a rather large printer but it could be sliced into two halves and attached together in theory. I personally printed it in a rather large printer at like a 70 degree angle, it took a while but worked perfectly fine.