SlimeX-FDM BMI270 case remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For DIY SlimeVR FBT without a PCB
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 112
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Share Alike
Go check out Yasu3D's Slime-X FDM GitHub page
I personally think the SlimeX-FDM case is the best looking design for DIY trackers without a custom PCB, however I was left unsatisfied with the original case design. This remix fixes a few flaws with the original design, most notably allowing a screw to be used to prevent the case from suddenly unlatching during use (and sending all your precious components flying across the room)
Fits one M3*12 machine screw
Use VHB tape or another adhesive to attach the IMU board to the case
I used a bluetooth label maker to make little position labels
This remix is designed for the Kuonolab BMI270 PCB footprint, it may be compatible with more modern IMUs that use the same footprint.
No supports required