1 / 4
Dutch Row House
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Dutch row house featured on the Stroopwafels box. Roughly 1∶160 scale to a real building.
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 68
- Wydruki
- 1
- Wyświetlenia
- 457
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (8)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (39)Powiązane
I modeled one of the Dutch row houses featured on the Stroopwafels box. The model is the same size as the picture on the box and roughly 1∶160 scale to a real building. To create the model follow the steps below:
- Print the windows. If they are not printing well try scaling up the size of the model.
- Print the top and make sure to enable all supports for this piece.
- Print the front. To get the best surface finish make sure there are one or two layers of infill.
- Print the back.
- Superglue the windows (except for the top one) onto the front of the building.
- Superglue the front to the back of the building.
- Superglue the top onto the back/front.
- Superglue the top set of windows and the top trim to the top.
This model was printed on an Anycubic Mega Zero 2.0 with a 0.4 mm nozzle in HATCHBOX PLA filament.
Note: the windows can be difficult to print, make sure the print bed is level and has good adhesion.