Tektronix Oscilloscope Feet (TDS 3000)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement Feet for Tektronix TDS3000-series oscilloscopes
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 112
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
The feet modules of the Tektronix TDS3000-series tend to crack and break after decades of use. This can lead to the oscilloscope being unstable, or you may not being able to use the feet at all.
This model is a foot module which replaces the original. It consists of two parts; the foot housing, and the foot lever. It's very similar to the original part, but with some changes to make it printable. It should fit the TDS3000, 3000B and 3000C series, because they all use the same case as far as I'm aware.
I have also added an additional version of the foot lever, with a hole to fit a soft bumper to prevent the oscilloscope from moving as easily when the feet are folded.
Printing
Use supports for the overhanging edges.
Print in a strong plastic, such as ASA or PC
Print two of each part
If printing the optional bumper use TPU; I used 95A hardness. 30-50% infill recommended.
Assembly/Installation
The foot lever clips into the housing.
The optional TPU bumper clips into the foot lever. Be aware that it has a slight angle to offset the angle of the housing, so it is orientation sensitive.
The feet are sandwiched between the oscilloscope case halves, so you will need to open it.
Once you've removed the rear case, you can slide out the old feet and install the new ones. Simple!