Decorate the Christmas Tree with the Little Angel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Let's have fun by decorating the Christmas tree.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 96
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Standard Digital File License
Let's have fun by decorating the Christmas tree.
How to play:
Unhook the bells and let the angel fly down to his platform.
Then take a ball, place it inside the angel, grab the bells, pull them, the strings attached to the angel wings will make him fly up.
Carefully, make the little angel follow the tinsel and drop the ball to its support.
When every ball is in place, attached the angel at the top of the Christmas tree by placing the bells under the supports that are fixed on the candles.
You can play alone, with family or friends and see who is the quickest.
Record to beat: 3 min 20 s
Little tip: it's easier to begin with the top balls.
How to assemble it:
You will need 2 pieces of nylon wire, measuring at least 35 cm each, I used nylon wire with a diameter of 0,25 mm.

You will also need a little bit of glue and 4 crimp beads (2 mm), you can replace them with big knots or a drop of hot glue.
Fit the panel and the candles on the stand.
Stick 4 silicon bumpers (8 mm in diameter) to each corner at the bottom of the stand.
Thread one wing of the angel with the nylon wire, attached a crimp bead under his wing. For a better hold, you should make a loop around the crimp bead. It will assure a better strength, (pass twice the thread in the crimp bead).
Now you can thread the candle from inside to outside.
Attached the stopper to the wire. The top of the stopper should be at 25,5 cm of the top of the wing. Put a drop of glue under the stopper.
Now you can thread the bell. The top of the bell should be 3 cm underneath the stopper. Stop the bell with a crimp bead hide underneath.
Repeat the same operations for the other wing.
For assembling the balls (6 big and 4 small), cut 10 pieces of 3D filament (1,75mm diameter) measuring 0,7cm each. Reunite the half balls with the piece of filament inserted in the holes. Add some glue to fix them definitely. If the balls are not perfectly round, you should file the joint.