1 / 3
Qi2 Wireless Charger Anker Zolo  Ford Focus MK2 — zdjęcie 1
1 / 3

Qi2 Wireless Charger Anker Zolo Ford Focus MK2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Qi2 Wireless Charger holder for Anker Zolo built into a Ford Focus MK2. Remix of two existing designs to suit my needs.

Ocena
0 / 5
Polubienia
4
Pobrania
41
Wydruki
0
Wyświetlenia
433
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a remix of the anker zolo stand https://makerworld.com/en/models/1822218-anker-zolo-magnetic-charger-stand-qi-2-magsafe#profileId-1945131 and https://www.printables.com/model/619781-usb-from-ford-focus-mk2 into a phone holder for my car. 

I printed in PLA, which has held up fine. The red was with a longer rod, the black picture with a shorter rod (30mm). If i was to print it again, it would be in PETG and probabily 35mm or so.

Update: Both PLA and PETG melted in the summer heat. Now trying ASA, will update if this does hold... 

The rod and the carger is held together by 2 m5x20mm bolts with nuts, this gives it some adjustability but the process of assembeling is quite complex as i'm nog a great designer. It requires some creative bolt tightening, but without locking nuts this should be more doable. Be warned however before you start that this could be a hastle. 

Tagi