Makita 12V battery to XT30 adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A very slim adapter for makita 12v batteries
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 242
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
This adapter was made primarily to allow the use of a 12v makita battery as a power source for my TS100 soldering iron, as I carry both on a daily basis and often don't have access to outlets.
The adapter adds only about 7mm of height over the battery and fits very snugly onto the battery. Better than my makita tools, in fact.
The adapter has two prongs that interface with the battery. These are regular cable lugs (male) that have ben bent and mounted so as to stick through the main body, as seen below.
top side
underside
The cables from the connector are fed through the small hole in the main part and crimped onto the cable lugs. I also glued them just in case but I doubt it is needed as the fit is pretty tight.
Bill of materials
8 M3x6 machine screws
1 XT30 female connector
2 male cable lugs
1,5mm2 (16 AWG) wire
heat shrink tubing
If you have any questions or requests regarding this model, feel free to comment or reach out.