Weller WE1010 - Skadis Board Mount

Weller WE1010 IKEA Skådis Board Mount (WIP)

This Skådis-mounted variant of the Weller WE1010 holder was created at the request of another user and is providedas a work in progress until real-world fitment is confirmed.

This design assumes standard IKEA Skådis dimensions and rear clearance as shown in the reference image(s).

---

Features

***50 mm spacer bracket** provides clearance for right-angle power connectors and preserves rear ventilation/exhaust

• Spacer extends to the bottom edge of the Weller bracket toreduce torsional load on the mount and fasteners ***Slotted mounting holes** accept 7–9 mm washers and allowdrop-through / printed Skådis nuts to be installed from the front
• Recessed bolt heads sit ~3 mm below the rear surface for a cleaner install and reduced snag risk

---

Hardware

***Fasteners:**

• M3 or M4 ×60 mm recommended
• Nominal required length is ~56–58 mm depending on washer and nut style
• Using M3×60 is recommended for ease of sourcing and tolerance stack-up ***Washers:**
• 7–9 mm OD flat washers required ***Nuts:**
• Drop-in / printed Skådis nuts or equivalent
• Standard hex nuts may work but will require rear access to the board

⚠ Note: Extra bolt length may protrude behind the Skådis board. This is normal and typically clears the rear relief channel.

---

Materials & Print Settings

***Recommended materials:** PETG, PA6-CF, PA12-CF ***PLA is not recommended** due to long-term creep under load

• Printed honeycomb core is intentional to balance stiffness, weight, and print time
• No supports required

---

Print Orientation

STLs are oriented correctly as provided. Print with therear face of the spacer against the build plate.

---

Notes / Limitations

• Minor side-to-side play may occur due toSkådis slot tolerances, especially with m3 bolts
• The Skadis bolt slots are spec'd at precisely 5mm, if your horizontal extrusion multiplier isn't precisely tuned and the drop in nuts you use are very tight tolerance, you may need to load the nut from the backside or file away some material - this can be updated in the model if needed
• This mount is intended for normal use (placing/removing the iron, plugging/unplugging cables)
• This is not designed to support heavy lateral loads or abuse
• Feedback is welcome — this design may be revised based on user fitment reports

---

If you do not need Skådis compatibility, use the standardunder-desk mount instead.

Category: Tool Holders & Boxes