1 / 6
Philips Hue Play x Amazon Basics Monitor Arm - Mounting Bracket — zdjęcie 1
1 / 6

Philips Hue Play x Amazon Basics Monitor Arm - Mounting Bracket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Updated 9/11/24:Added no-zip tie opening model as recommended default.I have ran this for nearly a year with petg and…

Ocena
0 / 5
Polubienia
0
Pobrania
8
Wydruki
0
Wyświetlenia
140
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

###Updated 9/11/24:

Added no-zip tie opening model as recommended default.

  • I have ran this for nearly a year with petg and no zip tie and not once had to readjust the brackets. They sit tight and hold over time despite the heat involved.
  • I included the slim ziptie opening version for those it might interest, beware how slim it is though.*

Phillips Hue Play x Amazon Basics Monitor Arm Bracket

This is a snap-fit bracket that mounts a Philips Hue Play lightbar 1" above the rotational "knuckle" (the non-rotating part of it) in a landscape orientation.

Advantages

  • prevents the use of strong adhesive on the back of expensive monitors
  • allows the monitor to freely re-orient independent of the lightbar.

Print Calibration Settings

**If you use the zip tie version:***beware it wont fit most zip ties and print the bracket with 7 top and 7 bottom layers at .25mm layer height for maximum strength.*

###The tolerances are tight by design.

Make sure your printer is calibrated and belts tight and such and you shouldn't have a problem.

Install

  1. Attach the lightbar to the bracket 2.pushing the bracket not the lightbar and supporting the underside of the arm, snap the bracket onto the two sides of the "D" shaped rotational bracket on the monitor arm.

I'd recommend PETG for two reasons:

  1. The tight tolerances will stress the plastic over time, to some extent.
  2. The Hue Play lightbars generate an enormous amount of heat for being consumer LED lights, possibly enough to make PLA (ever so slightly) pliable which is why I refuse to print with PLA anymore. Spend the time refining your printer for PETG and make the switch (if strong, functional prints are your main focus).

You will have to tighten the lift spring on your monitors arm if it is at the low end of the force required to lift your monitor once the lightbar is added.

Print Settings

Printer:

TEVO Tornado

Rafts:

Yes

Supports:

Doesn't Matter

Resolution:

.25

Infill:

40

Filament: eSun PETG Purple

Notes:

I used a raft because I have encountered curling from thin print features in the past. I also used 15% density light supports only over the build plate for the recessed screwhead on the back of the hue mount, a needle nose pliers extracts this easily even with PETG. Use your own discretion and experience to determine if you need a raft, brim, or nothing.

Category: Gadgets

Tagi