Stacking Display Boxes (Sichtlagerboxen) Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed version of JH3D's wall mount for better printability and looks.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 139
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I modified JH3D's wall mount for stacking display boxes to not only look better, but also improve printability. I also converted the mesh into a FreeCAD body. The overall dimensions were preserved.
I used 3.5x16mm countersunk screws, but 4mm screws should fit as well. I intentionally oversized the countersink, so you might also get away with even bigger screws after drilling the holes to the appropriate size. You just have to make sure the screw hat sits flush with the surface.
The screw holes are offset 30mm from the top and spaced at 40 mm.
Keep in mind that the model is orientated standing up (like you would mount it), while it should obviously be printed laying flat. This is how the original model was made and I didn't bother to rotate.